Wall Mount A Cap L2 Using A Cap L2 Hybrid Fiber Splice Box Kit (Optional) - CommScope ERA CAP L2 18/21/ 23T/26 F-DC Installation Manual

After you have wired the Hybrid Fiber Splice box, complete the steps in
CAP L2 Hybrid Fiber Splice Box Kit (optional)" on page
2

Wall Mount a CAP L2 Using a CAP L2 Hybrid Fiber Splice Box Kit (optional)

The steps in this section pertain only to those installations that require the use of the optional Hybrid
Fiber Splice Box to provide fiber and power to the CAP L2.
Remove the Hybrid Fiber Box cover.
Attach the Hybrid Fiber Splice Box to the Wall Bracket with the three captive screws already installed in
1
the Splice Box.
2
Replace the cover.
3
Attach the assembled Wall Mounting Bracket and Hybrid Splice Box to the selected mounting location.
If required, install an SFP+ module and follow the instructions in
4
(optional)" on page
5
Follow procedure in
6
M0203A9B_uc
© September 2022 CommScope, Inc.
42.
"Mounting CAP L2 with a Wall Mounting Kit" on page
"Wall Mount a CAP L2 Using a
35.
"Installing SFP+ Modules in the CAP L2
21.
CommScope ERA
Mount the Fiber CAP L2
® CAP L2 with Fiber Interface
Page 35