Installing CAP Ms
On lower right of the CAP M-2, reinstall the M6x12 screw and its washers that you removed in Step 13 on
17
page 36.
Slide first the M6 split-lock washer and then the M6 plain washer over the M6x12 screw.
a
Insert the M6x12 screw through the screw hole shown below, and screw it back into the CAP M
b
chassis; torque to 11 N-m.
18 Repeat Step 11 on the left side of CAP M-2.
19 Do one of the following:
If this installation requires a Hybrid Fiber Splice Box, go to "Attach a Hybrid Fiber Splice Box to the
•
CAP M" on page 42.
If this installation does not a Hybrid Fiber Splice Box, go to "Grounding the CAP M" on page 46.
•
™
Era
Medium Power Carrier Access Point Installation Guide
Page 38
M6x12 screw and
washer set in hole
furthest from the
moun ng surface
M0201AJB
© October 2018 CommScope, Inc.