CommScope Era CAP M 9 Installation Manual page 36

Installing CAP Ms
Refer to "Determine the Mounting Site" on page 16 to determine the mounting location, which must be
3
able to support the weight and dimensions of the CAP M.
Installer must verify that the mounting surface will safely support the combined load of the electronic
equipment and all attached hardware and components.
Refer to "Mounting Orientation" on page 24 to determine the mounting orientation of the CAP M.
4
Refer to and observe all cautions listed in "General Mounting Cautions" on page 23.
5
Secure the Mounting Bracket to the wall (or other suitable vertical surface) as shown below.
6
Install the mounting bracket using 4 M6 screw anchors (not included) or suitable lag bolts according
a
to the drilling layout.
The M6 screw anchors do not ship with the CAP M as the anchor type is dependent on the on-site
conditions (wall structure and materials). Use screw anchors that are rated for the mounting surface.
Confirm that the bracket is securely fastened to the wall.
b
™
Era Medium Power Carrier Access Point Installation Guide
Page 32
Dual Moun ng Bracket
1
4
1 4
through
are the four screw anchors
2
3
© October 2018 CommScope, Inc.
M0201AJB