Installing CAP Ms
On lower right of the CAP M, reinstall the M6x12 screw and its washers that you removed in Step 7 on
11
page 27.
Slide first the M6 plain washer and then the M6 split-lock washer over the M6x12 screw.
a
Insert the M6x12 screw through the screw hole shown below, and screw it back into the CAP M
b
chassis; torque to 11 N-m.
12 Repeat Step 11 on the left side of the CAP M.
13 Do one of the following:
If this installation requires a Hybrid Fiber Splice Box, go to "Attach a Hybrid Fiber Splice Box to the
•
CAP M" on page 42.
If this installation does not a Hybrid Fiber Splice Box, go to "Grounding the CAP M" on page 46.
•
™
Era
Medium Power Carrier Access Point Installation Guide
Page 30
M6x12 screw
and
washer set
M0201AJB
© October 2018 CommScope, Inc.