14 Use both handles on the CAP M-2 chassis to lift it above the Mounting Bracket with the back of its chassis
facing the back of CAP M-1, and then lower it into place.
The M6 pins that you loosened in Step 13 on page 36 must align with the Mounting Bracket slots, as
•
shown below.
The washer for each M6 pin should be next to the CAP M-2 chassis (inside the bracket).
•
15 On the right side of the CAP M-2, torque the M6 pin to 11 N-m.
16 Repeat Step 15 on the left side of the CAP M.
M0201AJB
© October 2018 CommScope, Inc.
CAP M-2
(back of the CAP M-2 chassis
faces the back of CAP M-1)
™
Era
Medium Power Carrier Access Point Installation Guide
Installing CAP Ms
M6 Pin with its
washer on the inside
of the bracket,
against the
CAP-M2 chasssis
Page 37