CommScope Era CAP M 9 Installation Manual page 44

Installing CAP Ms
Follow the steps in "Unpack and Inspect the CAP M and Optional Accessories" on page 19. Table 9 lists the
3
parts that ship with the CAP M Pole Mounting Kit for Up to 18" Poles.
Refer to "Determine the Mounting Site" on page 16 to determine the mounting location, which must be
4
able to support the weight and dimensions of the CAP M.
Installer must verify that the mounting surface will safely support the combined load of the electronic
equipment and all attached hardware and components.
Refer to "Mounting Orientation" on page 24 to determine the mounting orientation of the CAP M.
5
Refer to and observe all cautions listed in "General Mounting Cautions" on page 23.
6
Attach either a Single
7
Mounting Bracket
(CommScope PN
7821955-xx) or a Dual
Mounting Bracket
(CommScope PN
7821954-xx) to the two
screw pins on one of the two
Pole-Mounting Brackets.
Attach the M6 nut and
washers in the order shown.
Slide one M6 plain
a
washer (7A) over each
screw pin.
Slide one M6 split-lock
b
washer (7B) over each
screw pin, next to the M6
plain washer.
Secure one M6 Hexagon
c
Nut (7A) to the end of
each screw pin, and then
torque to 11 N-m.
Repeat Step 7 on the second Pole-Mounting Bracket.
8
The balance of this procedure may require two installers to complete.
™
Era Medium Power Carrier Access Point Installation Guide
Page 40
Table 9. Parts List for CommScope PN 7692096-XX
Description Quantity
Pole-Mounting Bracket 2
Bracket 2
M6 Hexagon Nut 4
M6 Plain Washer 4
M6 Split-Lock Washer 4
Dual-Moun ng
Bracket
Description Quantity
M8 Threaded Bolt 8
M8 Hexagon Nut 8
M8 Plain Washer 16
M8 Split-Lock Washer 8
M8 Nut 8
Pole-Moun ng
Brackets
Screw
pin
7a
7c
7b
M0201AJB
© October 2018 CommScope, Inc.