CommScope Era CAP M 9 Installation Manual page 38

Installing CAP Ms
Use both handles on the CAP M-1 chassis to lift it above the Mounting Bracket, and with the front of the
8
chassis facing the mounting surface, lower it into place.
The M6 pins that you loosened in Step 7 on page 33 must align with the Mounting Bracket slots, as
•
shown below.
The washer for each M6 pin should be next to the CAP M-1 chassis (inside the bracket).
•
On the right side of the CAP M-1, torque the M6 pin to 11 N-m.
9
10 Repeat Step 9 on the left side of the CAP M.
™
Era Medium Power Carrier Access Point Installation Guide
Page 34
CAP M-1
(front of the CAP M-1 chassis
faces the moun ng surface)
M6 Pin with its
washer on the inside
of the bracket,
against the
CAP-M1 chasssis
M0201AJB
© October 2018 CommScope, Inc.