Wall Mounting a CAP H
This procedure tells you how to mount the CAP H to a wall using the Wall Mounting Kit (CommScope Part
Number 7661581).
It is the responsibility of the installer to verify that the supporting surface will safely support the combined
load of the electronic equipment and all attached hardware and components and to ensure that the CAP H
is safely and securely mounted.
Mark the position of the drilling holes. The following graphic shows the location of the mounting holes
1
and the pitch of the CAP H during the mounting procedure.
Minimum:
775 mm (30.51")
Maximum
788 mm (31")
Moun ng Hole Loca ons
M0201AKB_uc
© January 2019 CommScope, Inc.
135mm
(5.31")
CommScope Era
Moun ng Pitch
™
High Power Carrier Access Point Installation Guide — Preliminary
Installing a CAP H
Page 25