King Industrial KC-60FX Instruction Manual page 22

MOUNTING CUTTERHEAD GUARD
1. Mount the cutterhead guard (A) by inserting the post (B) into the hole on the front of
the infeed table.
2. Turn the knob (C) under the infeed table right, before you fit the cutterhead guard post
through the hole.
3. Make sure that the slot on the cutterhead guard post engages the spring that can be
seen through the hole.
4. Check if the cutterhead gaurd operates normally by shifting the cutterhead guard,
then releasing it. If it is functioning properly, the cutterhead should return completely.
If not, the tension of the spring should be adjusted.
5. If the spring tension is insufficient, lift the cutterhead guard so that it disengages
the spring. Then turn the knob right, to increase the spring tension.
CUTTERHEAD GUARD (A)
POST (B)
KNOB (C)