Replacing The Knives - King Industrial KC-60FX Instruction Manual

REPLACING THE KNIVES

1. Before replacing the knives, be sure to disconnect the machine from the
power source.
2. Remove the cutterhead guard.
3. Loosen the four fixing screws (A) that tighten the knives.
4. Remove the knife (C).
5. Remove the fixing gib (B).
6. Clean all parts and the cutterhead slot before mounting the knives.
7. Fit the fixing gib and fixing screws.
8. Mount the knives. Ensure that the edge of the knife is facing in the correct
direction.
9. Adjust the knife height so that it is 1/16'' over the cutterhead drum.
10. Tighten the fixing screws securely.
11. Make the height adjustment for the three knives so that they are at the same
height.
12. Make knife adjustments to the outfeed table.
!
WARNING!
The knives are very sharp, care
should be taken when replacing
the knives.
!
WARNING!
Tighten the knife fixing screws
securely, otherwise a serious
accident may occur.