King Industrial KC-60FX Instruction Manual page 12

MOUNTING THE JOINTER ONTO THE STAND
1. The stand top has been predrilled with three holes for fastening the jointer onto the
enclosed stand.
2. The infeed end of the jointer should be fastened to the front two holes (A) of the stand.
3. The outfeed end of the jointer should be fastened to the rear single hole (B) of the
stand.
4. Tighten the jointer to the stand using the three special bolts (C) furnished with the
machine.
MOUNTING THE MOTOR ONTO THE STAND
Attach the motor to the bottom of the dust chute using the four 5/16'' bolts (A), flat
washers, and hex nuts. Do not fully tighten the hex nut at this time, because the
motor will need to be adjusted for belt tension.