King Industrial KC-60FX Instruction Manual page 18

ADJUSTING THE KNIFE AND OUTFEED TABLE
1. Turn off and unplug the machine.
2. Adjust the height of the rear table until it is 1/16'' above the cutterhead drum. To
make this adjustment, place a steel gauge (B) on the table, and use a thickness
gauge (A) of 1/16'' to obtain the correct height.
The knives must not only be adjusted to the same height as the outfeed table, but
they need to be precisely with it. If the knives are not exactly even with the outfeed
table, perform the following.
3. Place the steel gauge across the knife edge and outfeed table.
4. The outfeed table and steel gauge should be at the same height.
5. If the outfeed table and the steel gauge are not at the same height, then adjust
the height of the knives.
6. IMPORTANT: When checking the same height between the knife edges and the
outfeed table, it is important to check both ends of each knife. This will keep the
knives and the outfeed table parallel.