King Industrial KC-60FX Instruction Manual page 14

SETTING FENCE AT A 90
1. Before adjusting the fence at a 90
table. Adjust the infeed table so that it is parallel with the outfeed table.
2. Loosen the lock lever (A). Move the fence towards the front of the machine so
that it leans on the table.
3. Place a straight edge ruler on the table and against the fence.
4. Verify to see if the fence is at a 90
5. If the fence is not at a 90
6. Loosen the stop nut (B), flip the 90
adjust the fence to a 90
7. Replace set plate, unscrew stop bolt until it touches the set plate and tighten the stop
nut (B) after having adjusted the fence at a 90
STOP NUT (B)
STOP BOLT (D)
SET PLATE (C)
0 angle, adjust the positionning of the infeed
0 angle to the table.
0 angle to the table, please use the following instructions;
0 set plate (C) and screw in stop bolt (D) and
0 angle with your straight edge ruler.
ANGLE
0
0 angle.
LOCK LEVER (A)