Chapter 2 Getting Started; Start The Miseq; Customize System Settings - illumina MiSeq System Manual

Hide thumbs Also See for MiSeq:

Table of Contents

Chapter 2 Getting Started

Configure Notifications of BaseSpace Updates

Set Email Preferences

Set Default Folder Locations

User-Supplied Consumables

Start the MiSeq

Switch the toggle power switch on the back of the instrument to the | (on) position.

NOTE

For best performance, leave the instrument on continuously. However, if the instrument must be turned

off, see

Shut Down the Instrument on page

switch back to the ON position

Figure 9 Power Switch Location

Wait for the system to load, and then log on to the operating system. If necessary, consult your facility

administrator for the user name and password.

When the operating system is loaded, the MiSeq Control Software (MCS) launches and initializes the

system automatically.

For Local Run Manager, if user management is enabled, log in using your Local Run Manager user name

and password, and select Next.

Customize System Settings

From the Home screen, select Run Options.

Select the Run Settings tab.

Select Post Run Wash or Maintenance Wash.

An instrument wash is required after each run. The software requires that a wash is performed before

setting up a subsequent run. The Post-Run Wash Option specifies the type of wash that is performed by

default. A post-run wash takes approximately 30 minutes. A maintenance wash takes approximately 1

hour.

Document # 15027617 v04 Material # 20024228

For Research Use Only. Not for use in diagnostic procedures.

39. Wait a minimum of 60 seconds before turning the power

Table of Contents