6.
Initial Setup
6.4
Power Connection
WARNING – Electrical shock hazard:
Contact with components under electrical
power can result in a life-threatening elec-
trical shock.
Inspect the plug and power cord for da-
mage before connecting the unit to the
mains power supply.
Never use damaged components for esta-
blishing the mains power connection!
Connect the unit to a properly installed and grounded
power supply with the following connection values:
•
Fuse
•
Power overload cut-out
Establishing the mains power connection:
1. Before connecting the unit to the mains power
supply, make sure the supply outlets electrical ra-
ting matches the information on the nameplate on
the front of the unit. If the values for voltage (V)
and maximum current (A) do not agree, do not
connect the unit.
2. Insert the grounded unit connector [2] into the
socket [1] on the unit circuit cabinet.
3. Insert the grounded connector on [3] the power
cord into a properly grounded and protected wall
outlet.
4. Make sure there is no tension or pressure on the
power cord.
Figure 17
Fig.. 17, Power connection
T 16 A
G 16
1
2
- 30 -
®
HERAcell
240 CO
Incubator Operating Instructions
2
3
Version: 03.2001 / 50065640