Fig. 15 Center Support Installation - Kendro HERAcell 240 Operating Instructions Manual

6. Initial Setup
Center Support Installation:
If the CO incubator is equipped with the optional divi-
2
ded insert trays, tow center supports [1] with perfora-
tions are installed in addition to the support profiles on
the sides.
In this case, the support brackets are inserted in the
side support profiles and the perforations on the left
and right sides of the center supports.
1. The upper rectangular guide [3] of the center sup-
port is under spring force. First insert this rectan-
gular guide into the retainer on the sample
chamber ceiling [2], then press down gently so
that the rectangular guide pushes itself into the
center support.
2. Then insert the lower round peg guide [5] of the
center support into the opening [6] on the sample
chamber floor and release the spring pressure.
3. The spring pressure stabilizes the center support.
HERAcell
Figure 15
Fig. 15, Center support installation
- 28 -
®
240 CO Incubator Operating Instructions
2
Version: 03.2001 / 50065640