Installing/mounting
4.2 Mounting the linear actuator
4.1.1
Proper mounting
NOTICE
Incorrect mounting
The device can be damaged, destroyed, or its functionality impaired through improper
mounting.
• Before installing ensure there is no visible damage to the device.
• Make sure that process connectors are clean, and suitable gaskets and glands are
• Mount the device using suitable tools. Refer to the information in Technical data
Loss of degree of protection
Damage to device if the enclosure is open or not properly closed. The degree of protection
specified on the nameplate or in Chapter "Technical data (Page 241)" is no longer
guaranteed.
• Make sure that the device is securely closed.
4.2
Mounting the linear actuator
Requirements
There are linear actuators for standard mounting in accordance with IEC 60534 and for
integrated pneumatic mounting. Use the reduced mounting kit 6DR4004-8VK for actuators
with integrated mounting.
34
used.
(Page 241) for installation torque requirements.
CAUTION
SIPART PS2 with and without HART
Operating Instructions, 09/2014, A5E00074631-12