Siemens 6DR50 Series Operating Instructions Manual page 198

Parameterizing/addressing
9.4 Description of parameters
O1.LIMIT - Limit for number of changes in direction
Use this sub-parameter to set the base limit for the number of changes of direction of the
actuator. Set the base limit in a range from "1" to "1.00E8".
The factory setting is "1.00E6".
O2.FACT1 - factor 1
Use this sub-parameter to set the factor for the formation of limit threshold 1. Set the factor in
a range from "0.1" to "40.0". The limit threshold is the product of "O1.LIMIT" and
"O2.FACT1".
The threshold 1 error message is displayed when the limit threshold 1 is exceeded. The
procedure to activate and display this error message is described in the "XDIAG" parameter.
The factory setting is "1.0".
O3.FACT2 - factor 2
Use this sub-parameter to set the factor for the formation of limit threshold 2. Set the factor in
a range from "0.1" to "40.0". The limit threshold is the product of "O1.LIMIT" and
"O3.FACT2".
The threshold 2 error message is displayed when the limit threshold 2 is exceeded. The
procedure to activate and display this error message is described in the "XDIAG" parameter.
The factory setting is "2.0".
O4.FACT3 - factor 3
Use this sub-parameter to set the factor for the formation of limit threshold 3. Set the factor in
a range from "0.1" to "40.0". The limit threshold is the product of "O1.LIMIT" and
"O4.FACT3".
The threshold 3 error message is displayed when the limit threshold 3 is exceeded. The
procedure to activate and display this error message is described in the "XDIAG" parameter.
The factory setting is "5.0".
See also
Display of diagnostics values (Page 205)
196
SIPART PS2 with and without HART
Operating Instructions, 09/2014, A5E00074631-12