Function Check - Kessel Aqualift Comfort 230V Duo Instructions Manual For Installation, Operation And Maintenance

Type Aqualift
If the system pumps are tailored to the control unit (original KESSEL products), configure as per A). Otherwise,
proceed as per B).
• Press OK
• A) Select the type of the connected pump(s) with the arrow keys and confirm with OK; the 0 System info menu
is displayed – the control unit is now ready for operation.
• B) Select Special lifting station with the arrow keys and confirm with OK; the 0 System info menu is displayed.
You now need to configure all the system parameters. For floater and sensor settings, see 7.2 and 7.3.
Make sure that the power usage range displayed on the type plate of the connected pump(s) does not exceed
the maximum rating for the control unit. This could damage the control unit during operation and/or issue an error
message.
Maintenance interval
If no maintenance date is entered, this will be shown in plain text in the display. A maintenance date is entered
using the menu (see 6.1, Setting the maintenance date).
3.4.2

Function check

Preparation
- Make sure that the wastewater container that the pump(s) will drain can be filled with water in as short a time
as possible.
- In the wastewater container, apply a marking slightly below the filling level at which the alarm should be triggered.
For the function check, two different test procedures are carried out.
1. Check of the pump(s)
2. Check of the alarm switch
1. Check of the pump(s)
• Switch on the control unit.
• Switch off the pump temporarily using the manual control. T
o do so, actuate the <71>* key; the respective LED flashes
and the pump is switched off.
* In the Duo version, also actuate the <73> key
The control unit independently switches the manual control back to automatic operation after a short period of
time. The pump is then switched on after the respective filling level is reached. If the subsequent filling of the
wastewater container takes longer than this period of time, the manual control button(s) must be pressed again
to switch off the pump(s) temporarily..
2018/06
ASSEMBLY
47/68
Aqualift Comfort
[11]
69
71
73