Adding A Wireless Network Manually - Yealink SIP-T58V User Manual

Yealink SIP-T58V & T58A & T56A Smart Media Phones User Guide
Personal Identification Number (PIN): The user has to enter a WPS PIN generated randomly by the IP phone on the
l
gateway/router to connect.
Before You Begin
Make sure that the Wi-Fi mode is activated.
Push Button Configuration (PBC)
Procedure
1. Swipe left/right to go to the second idle screen.
2. Navigate to Settings->Basic Settings->Wi-Fi.
3. Tap and then tap WPS.
The touch screen prompts "Press the Wi-Fi Protected Setup button on your router. It may be called "WPS" or con-
tain this symbol:".
4. Long press the WPS key on your gateway/router.
Once WPS setup has completed successfully, the touch screen will prompt "Connected".
Personal Identification Number (PIN)
Procedure
1. Swipe left/right to go to the second idle screen.
2. Navigate to Settings->Basic Settings->Wi-Fi.
3. Tap and then tap WPS-PIN.
The touch screen prompts "Enter pin XXX on your Wi-Fi router. The setup can take up to two minutes to com-
plete.".
4. Note the PIN code.
5. Log into your gateway/router's web interface, and configure it to search the clients. For more information, refer to
the documentation from the gateway/router manufacturer.
Once the WPS-PIN setup has completed successfully, the gateway/router's web interface will prompt success.

Adding a Wireless Network Manually

If your gateway/router has SSID broadcast disabled, it might not appear in the scanning results. In that case, you must
manually add a wireless network.
Before You Begin
Get the available wireless network information from your system administrator. Make sure that the Wi-Fi mode is activ-
ated.
Procedure
1. Swipe left or right to go to the second idle screen. Navigate to Settings->Basic Settings->Wi-Fi.
2. Tap ->Add.
52