Selecting A Slave Handset For Your Phone; Push An Active Call To The Slave Handset - Yealink SIP-T58V User Manual

Master-Slave mode is available only when one handset is registered. For more information, refer to
tration.
Note
After the handset is bound to your phone as a slave handset, the assigned outgoing/incoming line(s) configured for the
handset by your administrator is disabled.
Topics

Selecting a Slave Handset for Your Phone

Push an Active Call to the Slave Handset

Pull an Active Call from the Slave Handset
Selecting a Slave Handset for Your Phone
You can select a slave handset for the phone, and configure a mode for whether to continue the conversation when
the phone goes off hook.
There are two slave modes:
Busy: You cannot switch the active call between the phone and slave handset. Regardless of the master handset or
l
the slave handset, the device which is during the call can initiate a new call. If you try to initiate a call on the
phone/handset, the phone/handset screen will prompt "Path Busy".
Take over call: When the slave handset is during the call, you can retrieve the call from the handset on the phone
l
after off-hook. When the phone is during the call, you can push the call to the slave handset.
Procedure
1. Swipe left or right to go to the second idle screen.
2. Navigate to DECT Settings->Select Slave.
3. Select the desired handset.
4. Select a mode from the Select mode: field.
5. Tap
.
Related Topics
Pull an Active Call from the Slave Handset
Push an Active Call to the Slave Handset
Push an Active Call to the Slave Handset
You can push the active call of the phone to the slave handset.
Before You Begin
The master phone is during a call, and the slave mode is selected as Take over call. And make sure there is only one
call on the phone.
Procedure
1. Swipe the soft key area left and then tap Call Shift.
The call is automatically connected on the slave handset.
Related Topic
Using Handsets on T58V/T58A/T56A Phone
Handset Regis-
207