Adding A Wireless Network Manually; Viewing The Wireless Network Information - Yealink Teams T55A User Manual

2. Tap
> WPS.
The device screen prompts that you need to press the Wi-Fi Protected Setup button on your router.
3. Long press the WPS key on your gateway/router.
Once the WPS setup has completed successfully, the touch screen will prompt connect successfully.
Connecting to the Wireless Network Using PIN
Before you begin
Make sure that the Wi-Fi mode is activated.
Procedure
1. Go to
> Settings > Device Settings > Wi-Fi.
2. Tap
> WPS-PIN to search the available wireless network.
The device screen prompts that you need to enter the PIN xxx on your WLAN router.
3. Log into your gateway/router's web interface, and configure it to search the clients.
Once the WPS-PIN setup completes successfully, the web interface of the gateway/router will prompt
success.

Adding a Wireless Network manually

If your gateway/router has SSID broadcast disabled, it might not appear in the scanning results. In that
case, you must manually add a wireless network.
Before you begin
Make sure Wi-Fi Mode is activated.
Procedure
1. Go to
> Settings > Device Settings > Wi-Fi.
2. Tap
> Add.
3. Enter the SSID and then select a security mode from the Security drop-down menu:
If you select None, tap Save.
•
If you select WEP or WPA/WPA2-PSK , enter the password and then tap Save.
•
If you select 802.1×EAP, select the desired EAP method and Phase-2 authentication , enter the
•
desired values in the Identity, Anonymous identity, and Password fields and then tap Save.
If you enable Show advanced options, select a desired value in the Proxy field; and if you select
Manual, enter the information about the proxy server in the corresponding fields.

Viewing the Wireless Network Information

After connecting to the wireless network, you can view the wireless network information (such as wireless
status, link speed, security, IP address, signal strength, and so on.)
Procedure
1. Go to
> Settings > Device Settings > Wi-Fi.
| Wireless Network | 52