Table of Contents
Advertisement
Monitoring of the
rotary axes and
secondary linear
axes
6 – 376
MP6520
Probing feed rate for tool measurement with non-rotating
tool
Input:
1 to 3000 [mm/min]
MP6570
Max. permissible surface cutting speed at the tooth edge
Input:
1.0000 to 129.0000 [m/min]
MP6572
Maximum permissible speed during tool measurement
Input:
1 to 1000 [rpm]
0: 1000 [rpm]
To ensure that the rotary axes and the secondary linear axes are always in a
defined position during the tool measuring cycles:
7 7 7 7
In MP6585, enter the axes to be monitored.
7 7 7 7
In MP6586, enter the reference coordinate at which the axis should be
located during the tool measuring cycles.
If, during activated monitoring, the nominal position does not match the
position from MP6586, an error message is displayed.
MP6585
Monitoring the position of the rotary and additional linear
axes during the tool measurement cycles
As of software version:280 476-01
Format:
%xxxxxx
Input:
0: Axis is not monitored
1: Axis is monitored
Bit 0 – A axis
Bit 1 – B axis
Bit 2 – C axis
Bit 3 – U axis
Bit 4 – V axis
Bit 5 – W axis
MP6586
Ref. coordinate for monitoring the position of the
rotary and additional linear axes during the tool
measurement cycles
As of software version:280 476-01
Input:
–99 999.9999 to +99 999.9999 [mm] or [°]
MP6586.0–5 Axes A to W
HEIDENHAIN Technical Manual TNC 426, TNC 430
Advertisement
Table of Contents
