Table of Contents
Advertisement
HEIDENHAIN conversational program
29 FN 3: Q200 = +Q200 * +Q30
30 FN 3: Q204 = +Q204 * +Q30
31 LBL 0
32 LBL 192
33 L Z+Q20 R0 F MAX
34 L Z+Q24 R0 FQ206
35 CYCL DEF 9.0 DWELL TIME
36 CYCL DEF 9.1 DWELL Q211
37 L Z+Q20 R0 FQ25
38 L Z+Q19 R0 F MAX
39 END PGM 201 MM P
9.4 Compatibility with Earlier OEM Cycles
9 – 10
The following possibilities are provided to enable you to continue using earlier
OEM cycles with program numbers 999 999 68.H to 999 999 99.H on the TNC.
Earlier OEM cycle:
n
Use CycleDesign to include the cycle in the cycle structure of the TNC. Like
a standard cycle, the cycle can be defined and called via soft key under
dialog guidance.
n
You can have the cycle run only in existing NC programs. The cycle cannot
be used by the TNC user in the new NC programs, but existing NC programs
containing the cycle can be run.
You can access earlier OEM cycles, even without CycleDesign.
Earlier OEM cycle:
n
Call with CYCL DEF 12 (program call) and CYCL CALL. The cycle cannot be
programmed by soft key. It is defined with CYCL DEF 12 and then called with
CYCL CALL or M99.
n
Call with PGM CALL. The cycle cannot be programmed by soft key. It is called
with PGM CALL.
You will find detailed information about the use of earlier OEM cycles in the
User's Manual for CycleDesign.
Comment
Approach the Z preparatory position
Traverse to total hole depth
If desired, dwell at bottom
Retract to setup clearance
If desired, retract to 2nd setup clearance
HEIDENHAIN Technical Manual TNC 426, TNC 430
Advertisement
Table of Contents
