HEIDENHAIN TNC 426 PB/M Technical Manual page 282

MP Function and input
MP6500 Tool measurement with TT 130
Format:
Input:
4 – 44
%xxxxxxxxxxxxxxx
Bit 7 – Reserved
Bit 8 – Probing routine
0: Probe contact is probed from several
directions
1: Probe contact is probed from one direction
Bit 9 – Automatic measurement of the
probe contact basic rotation (bit 8 = 1)
0: Basic rotation is not measured
1: Basic rotation of the probe element is
automatically measured
Bit 10 – Probing routine (bit 8 = 1)
0: Pre-positioning to starting point in all three
principle axes
1: Pre-positioning to starting point in the tool axis
and in the axis of the probing direction (MP6505)
(bit 9=0)
Bit 11 – "Tool checking" and changing in the
tool routine
0: After "tool checking" the
tool table is changed
1: After "tool checking" the
tool table is not changed
Bit 12 – PLC datum shift
0: Do not include
1: Include
Bit 13 –
0: Tool is measured in the tilt position
in which the tool touch probe
was also calibrated
1: Tool is measured in a different
tilt position
Bit 14 – Tool measurement with
number of teeth 0
0: Tool measurement with rotating spindle
1: Tool measurement with stationary spindle
HEIDENHAIN Technical Manual TNC 426, TNC 430
Software Page
version and
behavior
PLC 6 – 370,
6 – 371,
6 – 373,
6 – 375,
6 – 377