HEIDENHAIN TNC 426 PB/M Technical Manual page 297

MP Function and input
MP7431 Arc end-point tolerance
Input:
MP7440 Output of M functions
Format:
Input:
MP7441 Error message during cycle call
Format:
Input:
MP7442 Number of the M function for spindle orientation in the
cycles
Input:
December 2001
0.0001 to 0.016 [mm]
%xxxxxxx
Bit 0 – Program stop with M06
0: Program stop with M06
1: No program stop with M06
Bit 1 – Modal cycle call M89
0: Normal code transfer of M89 at beginning of
block
1: Modal cycle call M89 at end of block
Bit 2 – Program stop with M functions:
0: Program stop until acknowledgement
of the M function
1: No program stop. Acknowledgement
is not waited for.
Bit 3 – Switching of k
V
0: Function is not in effect
1: Function is in effect
Bit 4 – Reduced feed rate in the
tool axis with M103
0: Function is not in effect
1: Function is in effect
Bit 5 – Reserved
Bit 6 – Automatic activation of M134
0: M134 must be activated in the NC program
1: M134 is automatically activated when an NC
program is selected.
%xxx
Bit 0 –
0: Error message Spindle ? is not suppressed
1: Error message Spindle ? is suppressed
Bit 1: Reserved, enter 0
Bit 2 –
0: Error message Enter depth as negative is
suppressed
1: Error message Enter depth as negative is
suppressed
1 to 999: Number of the M function
0: No oriented spindle stop
-1: Spindle orientation by the NC
List of Machine Parameters
factors with M105/M106
Software Page
version and
behavior
PLC, CN123 6 – 326
RUN
PLC, CN123 6 – 47,
6 – 123,
RUN
6 – 125,
6 – 286,
6 – 455
280 474-04 6 – 286
PLC, CN123
RUN
280 476-09 6 – 201
PLC, CN123
RUN
4 – 59