Table of Contents
Advertisement
Help window with
HELP key
December 2001
The user selects a file:
n
By pressing the HELP soft key
n
By pressing the PGM MGT soft key
If a HELP file is selected in the foreground and background operating mode,
the error message PARALLEL OPERATION NOT POSSIBLE appears.
HELP files are saved externally with the identifier "J".
W270
Line number in help file
–1: No help file selected
–2: Not a valid numerical value
0 to 9999: Line number
If an NC error message appears:
7 7 7 7
Press the HELP key.
You will receive information on the cause and correction of the error.
To make such information available for PLC error messages as well, you must
save the texts in files:
7 7 7 7
Create two files:
• Texts under the heading "Cause of Error"
• Texts under the heading "Corrective Action"
7 7 7 7
Define the names of the files in the system file OEM.SYS with the
commands:
• PLCERRREASON= cause of error
• PLCERRFIX= corrective action
7 7 7 7
Save the files in the corresponding language directories
(PLC:\LANGUAGE\<language>).
7 7 7 7
With MP7230.3, select the active language (file).
Display and Operation
Set
Reset
NC
NC
6 – 277
Advertisement
Table of Contents
