Cisco ASA Series Cli Configuration Manual page 106

Monitoring the ASA Services Module
Router> show firewall module 11 state
Firewall module 11:
Switchport: Enabled
Administrative Mode: trunk
Operational Mode: trunk
Administrative Trunking Encapsulation: dot1q
Operational Trunking Encapsulation: dot1q
Negotiation of Trunking: Off
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 1 (default)
Trunking VLANs Enabled: 3,6,7,20-24,40,59,85,87-89,99-115,150,188-191,200,250,
501-505,913,972
Pruning VLANs Enabled: 2-1001
Vlans allowed on trunk:
Vlans allowed and active in management domain:
Vlans in spanning tree forwarding state and not pruned:
The following is sample output from the show firewall module [mod-num] traffic command:
Router> show firewall module 11 traffic
Firewall module 11:
Specified interface is up, line protocol is up (connected)
Hardware is EtherChannel, address is 0014.1cd5.bef6 (bia 0014.1cd5.bef6)
MTU 1500 bytes, BW 6000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Full-duplex, 1000Mb/s, media type is unknown
input flow-control is on, output flow-control is on
Members in this channel: Gi11/1 Gi11/2 Gi11/3 Gi11/4 Gi11/5 Gi11/6
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queuing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 10000 bits/sec, 17 packets/sec
8709 packets input, 845553 bytes, 0 no buffer
Received 745 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
18652077 packets output, 1480488712 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
The following is sample output from the show firewall multiple-vlan-interfaces command:
Router# show firewall multiple-vlan-interfaces
Multiple firewall vlan interfaces feature is enabled
The following is sample output from the show firewall module command:
Router# show firewall module
Module Vlan-groups
5
8
The following is sample output from the show firewall module [mod-num] version command:
Router# show firewall module 2 version
ASA Service Module 2:
Sw Version: 100.7(8)19
Cisco ASA Series ASDM Configuration Guide
1-12
50,52
51,52
Chapter 1 Configuring the Switch for Use with the ASA Services Module