Motor; Cutting Unit Joint - Husqvarna 520iHT4 Workshop Manual

3. Remove the eccentric element (D), the connecting
rod assembly (E) and the pins (F) from the gear.
4. Assemble in the opposite sequence.

5.9 Motor

5.9.1 To remove and install the motor
1. Remove the cutting unit. Refer to
the blades on page 21 .
2. Remove the gear package. Refer to
gear package on page 18 .
3. Remove the 2 screws from the motor bracket.
4. Remove the motor.
5. Install in the opposite sequence.

5.10 Cutting unit joint

5.10.1 To disassemble the cutting unit joint
1. Disconnect the motor cables. Refer to
and install the motor on page 22 .
2. Remove the air conductor. Refer to
air conductor on page 17 .
3. Remove the gear package. Refer to
gear package on page 18 .
22 - Repair instructions
4. Remove the motor. Refer to
5. Remove the lock washer.
D
E
F
G
6. Remove the screw and the joint cover.
To disassemble
To remove the
7. Disassemble the joint (A), the clamp (B), the bushing
To remove
To remove the
To remove the
the motor on page 22 .
(C) and the indexing ring (D).
A
B
C
To remove and install
D
1235 - 001 -