Replacing The Drive Pawls - Husqvarna 322 Workshop Manual

Starter
Fit the starter pulley.
Fit a new starter cord.
NOTE!
A new starter cord can be fitted without
the need of dismantling the starter!
Fit the starter handle.
Tension the return spring.
Check the spring tension.
Fit the starter on the engine body.
Do not forget the guide bushes for the
fuel tank.
Replacing the drive
pawls
Dismantle the drive cup.
504 91 06-05
Remove the circlip and replace the
drive pawl or spring if damaged.
Lubricate the axle spindle with a little
grease and fit the starter pulley.
Position the washer and tighten the
bolt.
Fit a new starter cord. Slide it into the
groove on the starter pulley as shown
in the diagram and out through the cord
guide in the starter housing.
Make sure the knot on the end of the
cord is as small as possible!
Fit the starter handle as described in
the Workshop Manual.
Tension the return spring. Pull out the
starter cord completely and lift it up
through the cut-out in the starter pulley.
Now turn the starter pulley 6 turns
anticlockwise .
Check the spring tension. With the cord
fully extended it should be possible to
turn the starter pulley at least a further
half turn.
Replacing the drive
pawls
Fit the piston stop, No. 504 91 06-05 in
the spark plug hole and loosen the nut
holding the drive cup.
Remove the circlip holding the drive
pawl.
Lift off the drive pawl and spring for
replacement.
Assemble in the reverse order as
stated for dismantling.
1
5