Condumax II User's Manual
Safety
This manual contains all the required information to install, operate and maintain the Condumax II.
Prior to installation and use of this instrument, this entire manual should be read and understood.
Installation and operation of this product should be carried out by suitably competent personnel only.
The operation of this product must be in accordance with the terms of this manual and associated
safety certificates. Incorrect installation and use of this product for other than its intended purpose
will render all warranties void.
This product is intended for use in a Hazardous Area and is awarded an ATEX, IECEx and CSA
Certificate. The relevant certificates should be fully examined prior to installation or use of this
product.
Where this hazard warning symbol appears in the following
sections, it is used to indicate areas where potentially hazardous
!
operations need to be carried out and where particular attention to
personal and personnel safety must be observed.
Electrical Safety
The instrument is designed to be completely safe when used with options and accessories supplied
by the manufacturer for use with the instrument. The input power supply voltage limits are 90 to
260 V AC, 47/63 Hz.
Pressure Safety
DO NOT permit pressures greater than the safe working pressure to be applied directly to the
instrument. Refer to the Technical Specifications in Appendix A.
Toxic Materials
The use of hazardous materials in the construction of this instrument has been minimized. During
normal operation it is not possible for the user to come into contact with any hazardous substance
which might be employed in the construction of the instrument. Care should, however, be exercised
during maintenance and the disposal of certain parts.
Repair and Maintenance
The instrument must only be maintained either by the manufacturer or an accredited service agent.
Refer to www.michell.com for details of Michell Instruments' worldwide offices contact information.
Calibration (factory validation)
Prior to shipment, both the hydrocarbon dew-point cell and the water dew-point cell undergo
stringent factory calibration to internationally traceable standards - NPL (UK) and NIST (USA). Due
to the inherent stability of the instruments, only periodic calibration maintenance is required under
normal operating conditions. Refer to Section 1.2.4 and 4.1 for more information.
Safety Conformity
This product meets the essential protection requirements of the relevant EU directives. Further
details of applied standards may be found in the product specification.
Michell Instruments
vii
Need help?
Do you have a question about the Condumax II and is the answer not in the manual?