Configuration - 2N IP Base Installation Manual

3.1 Configuration

Configuration takes place typically via a Web interface. Alternatively, it is possible to
configure using the software
via the web interface can be accessed as follows:
Launch your internet browser (Internet Explorer, Firefox, etc.).
Enter the IP address of your intercom (
Log in using the username
You have to know your intercom IP address to log in to the integrated web server.
®
Upon purchase, 2N
address automatically if there is a properly configured DHCP server in the LAN. If no
DHCP is available, operate
adress http://192.168.1.100).
If you do not know the IP address of the device it is also possible to use the
®
2N Network Scanner,
®
2N IndoorTouch in your network. You can find in section
If your device remains inaccessible (you have forgotten the IP address, the network
configuration has changed, etc.), you can change the network configuration using the
device buttons.
Refer to the Configuration manual for 2N IP intercoms
configuration details.
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2N Access Commander
Admin and password
IP Base is set to the dynamic IP address mode – it retrieves the IP
®
2N IP Base
which can find the
or service
http://192.168.1.100/
2n .
in the static IP address mode (in default state
2N IP intercom 2N
3.6 Downloads
My2N . Configuration
, e.g.).
®
, Access Unit
.
®
for the 2N IP Base
48/66
and