2N IP Base Installation Manual page 37

Caution
In case of resetting the factory default settings on a device with a
version of firmware 2.18 or higher it is necessary to reprogram the
®
2N Security Relay
IP Address Finding
Follow the instructions below to
Press and hold the RESET button.
Wait until the red and green LEDs on the device come on simultaneously
(approx. 20 s).
Release the RESET button.
The device announces the current IP address via the loudspeaker connected
automatically.
Static IP Address Setting
Follow the instructions below to switch on the
Press and hold the REST button.
Wait until the red and green LEDs on the device come on simultaneously
(approx. 20 s).
Wait until the red LED goes off (approx. 5 s).
Release the RESET button.
2N TELEKOMUNIKACE a.s., www.2n.cz
using the instructions from section
identify the current IP address
Static IP address
2.4 .
:
mode (DHCP OFF):
37/66