2N IP Base Installation Manual page 44

The device also supports a Departure button connected between the 'PB' and '-
HeliosIP/IP Intercom' terminals. Press the Departure button to activate the output for
5 seconds.
Status signalling:
Green LED Red LED
blinking off
on off
blinking blinking
on blinking
Configuration:
Connect the
refer to the C onfiguration manual for 2N IP intercoms
least on the 2N
Press and hold the
device in the programming mode (both the red and green LEDs are blinking).
Activate the intercom switch using the keypad, telephone, etc. The first code
sent from the intercom will be stored in the memory and considered valid. After
code initialisation, the
(the green LED is blinking).
Caution
In case of resetting the factory default settings on a device with a
version of firmware 2.18 or higher it is necessary to reprogram the 2N
Security Relay
2N TELEKOMUNIKACE a.s., www.2n.cz
Status
Operational mode
Activated output
Programming mode – waiting for initialisation
Error – wrong code received
®
2N Security Relay
®
Security Relay is on or blinking.
®
2N Security Relay
®
2N Security Relay
using the instructions above.
to the properly set intercom switch output;
. Make sure that one LED at
Reset button for 5 seconds to put the
will pass into the operational mode
®
44/66