rEMOvE COiN DrOP
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Remove the facia (See page 4-50).
2.
Remove two 1/4" security bolts from inside
the collar.
3.
Disconnect the wire connector from the
control board.
4.
Slide the Coin drop out the front of the
collar.
Two 1/4"
Security Bolts
Wire
Connector
4-62
rEMOvE COiN vaulT
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Remove the upper dryer (See page 4-58).
2.
Remove the coin vault switch
(See page 4-61).
3.
Remove two 9/16" hex nuts from the top of
the inside of the coin vault.
4.
Lift off the coin vault retaining bracket off the
top of the coin vault box.
5.
Slide the coin vault box back and remove it
from inside the collar.
Two 9/16"
Hex Bolts
Coin Vault
Retainer