Remove Exhaust Duct - Maytag MDE17CS Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Remove the Lint Filter Housing
(See page 4-21).
2. Remove the 1/4 hex head screw on the
front top of the duct
3. Push the duct towards the rear of the dryer
and off the blower housing then lift the duct
up and out.
4. To remove it from the rear of the dryer:
remove the 1/4 hex head screw from the
front top of the duct.
5. Push the duct towards the rear of the dryer
off of the blower housing and out the rear of
the dryer.
NOTE: Both procedures can be done with
the drum and blower installed.

rEMOvE ExHauST DuCT

1/4" Hex
Head Screw
4-32
6. Make sure the anti-vibration clip is installed
on the exhaust duct at the back of the dryer
prior to operation.
7. Insert the small clip into the hole next to the
exhaust duct opening.
8. Press down until the clip snaps securely into
place with the tab pressing firmly against the
exhaust duct.
Anti-Vibration
Clip Installed