rEvErSiNG a DOOr WiTH a WiNDOW
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Remove the door from the dryer
(See page 4-18).
2.
Remove the nine screws from around the
edge of the door including the hinges.
3.
Lift the front panel off the inside panel.
4.
Rotate the front panel half 180 degrees.
5.
Reassemble the door with the hinges on the
opposite end of the door.
6.
Remove the two hinge hole covers from
the front panel by removing two star head
screws from each cover.
7.
Reinstall these two covers over the hinge
holes on the opposite side of the front panel
frame.
8.
Reattach the door to the dryer with the door
swing in the opposite direction.
NOTE: Not all glass doors are reversible.
look for an indentation at the inside corner
of the door where the door switch actuator
will hit. If the indent is not there, then the
door is not reversible.
4-49
Two Star Head
Screws