Installing Leveling Legs, Payment Device, And Coin Box - Maytag MDG28PD Installation Instructions Manual

INSTALLING LEVELING LEGS, PAYMENT DEVICE, AND COIN BOX

The payment device, control panel lock and key, and coin box
lock and key are not included and are available from usual
industry sources.
1. Prepare dryer for leveling legs
NOTE: Slide dryer onto cardboard or hardboard before moving
to avoid damaging floor covering.
Using two or more people, move dryer to desired installation
location.
Take tape off front corners of dryer. Open dryer and remove
the literature and parts packages. Wipe drum interior with damp
cloth to remove any dust.
Take two cardboard corners from the dryer carton and place
them on the floor in back of the dryer. Firmly grasp body of the
dryer and gently lay it on its back on the cardboard corners.
2. Screw in leveling legs
Examine leveling legs and find diamond
marking. Screw legs into leg holes by
hand. Use an adjustable wrench or
25 mm (1") hex-head socket wrench to
finish turning legs until diamond marking
is no longer visible. Then fit a covered foot
boot over each leg foot. A longer leveling foot
(Part Number 279810) is available if needed
on extremely sloped floors.
To protect the floor, use a large piece of cardboard from the
dryer carton. Stand dryer up on the cardboard. Slide the dryer
until it is close to its final location. Leave enough room for
electrical connection and to connect the exhaust vent.
3. Install payment device and coin box
Remove the service door of the meter case by lifting
it up at the back. If applicable, install the money-accepting
device. (Refer to manufacturer's instructions for proper
installation.)
Replace the meter case service door. Put the coin vault
with lock and key in the meter case opening.
Remove cardboard or hardboard from under dryer. Adjust
the legs of the dryer up or down until the dryer is level.
Diamond
marking
Foot
15