Remove Control Panel - Mn; Remove Control Cover - Mn - Maytag MDE17CS Service Manual

rEMOvE CONTrOl
PaNEl - MN
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Open the control panel (See page 4-13).
2. Disconnect two wire connectors for the LED
indicator light.
3. Disconnect two spade connectors from the
start switch.
4. Disconnect seven spade connectors from
the selector switch.
5. Disconnect one single spade connector and
one three wire connector from the timer.
6. Disconnect one Earth wire clip.
7 Selector Switch
Connectors
2 Indicator Light
Connectors
1 Earth Wire Clip
2 Start Switch
Connectors
1 Single &
1 Three Wire Timer
Connectors
rEMOvE CONTrOl
COvEr - MN
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Open the control panel (See page 4-13).
2. Remove the eight 1/4" hex head screws that
secure the Control cover to the top of the
dryer. These screws are just sheet metal
screws so do not over tighten them when
reinstalling the control cover.
3. Lift the control cover off of the top of the
dryer and pass the control panel through the
control cover. Lay it on a covered surface.
NOTE: No components need to be removed
from control panel to accomplish removal of
the control cover.
4-17
Eight 1/4" Hex
Head Screws