Remove Service Panel - Maytag MDE17CS Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Insert a stiff putty knife or a thin flat blade
screwdriver in the slot below the door.
2. Slide the tool until it contacts a clip, about 5
cm (2") in from each corner.
3. Press the clip down to release it while
pulling the panel forward.

rEMOvE SErviCE PaNEl

Clip
4-56
4. Repeat this procedure with the other clip.
5. Pull the panel forward and remove the
panel.
6. The tech sheet, wiring diagrams, parts list,
programming information, and a key for the
service lock are in a pouch on the back side
of the service panel.
Tech
Sheet