General Safety Instructions - VETRON 5000 Programming Manual

PROGRAMMING MANUAL
08. GENERAL INFORMATION IMPORTANT FOR SAFETY

General Safety Instructions

This manual and the warning symbols on the machine
should ensure the safe use of the machine, so that
no accidents and injuries may occur. Please read this
instruction and also the safety instructions of the motor
manufacturer carefully.
The machine may only be set into operation after this
instruction manual has been read and the operator has
been trained by authorized personal.
The machine may only be used as specified and with
the appropriate safety devices. General safety instruc-
tions must be applied.
Take note of the danger and safety instructions on the
machine.
The machine must be switched o , or plug pulled
when maintenance and other work e.g. changing of
needle, sewing foot, needle plate, feed dog, bobbin or
threading is done, also when leaving the working place.
Daily maintenance work may only be taken out by
properly trained personnel.
Repairs and special maintenance may only be done
by technical personnel or specially trained sta .
Only qualified mechanic may take out work on the
electrical equipment.
Works on live parts are not allowed. Conversions or
modifications to the machine may only be done with
the common safety measures.
Only original VETRON spare parts or parts which are
cleared by VETRON are allowed to use when repairing
the machine. Failure to comply will void the warranty.
The machine can only be used when the whole unit
complies with the EC-Directive.
The connecting cable must be equipped with a
country-specific connecting plug. This must be done
by an electrician.
12 PROGRAMMING MANUAL VETRON 5000
Notice to the owner
This manual must be at all times be available for the
operator as it is part of the machine. Make sure that
the persons whom are working on the machine read
it before starting the machine for the first time.
The owner must make sure that the machine is in
good working order.
The owner must check that all safety devices are in
place and in working order.
The owner must make sure that only authorize,
trained persons are working on the machine
Operators and Technical Sta
It is the operator´s responsibility to take care of small
adjustments, operating and cleaning of the machine.
The operator has to refrain from any actions that can
interfere with the safety of the machine. There is no
jewelry, changings or rings to be worn while working
on the machine. The clothing should be tight fitting.
Only authorized personnel is allowed on the workplace.
The incidence of an error on the machine that can inter-
fere with the safety must be reported
to the supervisor.
The skilled technical sta is responsible for
lubricating, maintenance, repairing and adjusting
of the machine. The machine must be switched of
before starting any work on the machine and be
secured that it can´t be switched on by evident.
Exceptions are listed in the regulation EN 50110.
The safety guards must be replaced after finishing
the repair and maintenance work.
Operators and technical sta must take attention of
the safety and operating instructions in this manual.