VETRON 5000 Programming Manual page 29

NR. PARAMETER
» END BACKTACK
D Stitch lenght
145
146 CD speed
NR. PARAMETER
» SEAM END
150 Thread trimming
160 Backturn
NR. PARAMETER
» CHAIN PROGRAM
999 Chain program
PROGRAMMING MANUAL
DESCRIPTION
You can choose between:
STD = Stitch length for B in backtack same as length set in parameter 010
(Main stitch length).
4.0 mm = Stitch length for B in backtack can be choosen irrespectiv of the
main stitch length (parameter 010) (e.g. 4.0 mm).
-4.0 mm = When the stitch length for B in backtack is entered in the
minus range this part of the back tack will done in reverse.
800 S/min = Can be set between 50 – 2000 S/min (e.g. 800 S/min)
DESCRIPTION
You can choose between:
OFF = Thread trimmer is inactive.
ON = Thread trimmer is active.
You can choose between:
OFF = Backturn is inactive.
ON = Backturn is active.
DESCRIPTION
This parameter will show if a progam is used in a chain program.
INFO!
A chain program will be used when di erent operations on a work piece are done
one after the other. The machine will set itself automatically for the next work step.
12. PROGRAM PARAMETER
PROGRAMMING MANUAL VETRON 5000 29
-14-14