General Safety Instructions - VETRON 5000 Instruction Book

INSTRUCTION BOOK
08. GENERAL INFORMATION IMPORTANT FOR SAFETY

General Safety Instructions

This manual and the warning symbols on the machine should
ensure the safe use of the machine, so that no accidents and in-
juries may occur. Please read this instruction and also the safety
instructions of the motor manufacturer carefully.
The machine may only be set into operation after this instruction
manual has been read and the operator has been trained by au-
thorized personnel/sta .
The machine may only be used as specified and with the ap-
propriate safety devices. General safety instructions must be
applied.
Take note of the danger and safety instructions on the machine.
The machine must be switched o , or plug pulled during mainte-
nance and other work e.g. changing of needle, sewing foot, need-
le plate, feed dog, bobbin or threading is done, also when leaving
the working place.
Daily maintenance work may only be taken out by properly trai-
ned personnel.
Repairs and special maintenance may only be done by technical
personnel or specially trained sta .
Only a qualified mechanic may perform work on the electrical
equipment.
Working on movable parts is not allowed. Conversions or mo-
difications to the machine may only be done with the common
safety measures.
Only original VETRON spare parts or parts which are cleared
by VETRON are allowed to be used when repairing the machine.
Failure to comply will void the warranty.
The machine can only be used when the whole unit complies
with the EC-Directive.
The connecting cable must be equipped with a country-specific
connecting plug. This must be done by an electrician.
08/2017 08/2017
12 12
VETRON 5000/5100 - FLAT BED MACHINE VETRON 5000/5100 - FLAT BED MACHINE
Notice to the owner
This manual must be available at all times for the operator as
it is part of the machine. Make sure the persons working on the
machine read it before starting the machine for the first time.
The owner must make sure that the machine is in good working
order.
The owner must check that all safety devices are in place and in
working order.
The owner must make sure that only authorized, trained per-
sons are working on the machine.
Operators and Technical Sta
It is the operator´s responsibility to take care of small adjust-
ments, operating and cleaning of the machine.The operator has
to refrain from any actions that can interfere with the safety
of the machine. There is no jewelry, chains or rings to be worn
while working on the machine. The clothing should be tight fit-
ting. Only authorized personnel is allowed on the workplace. The
occurence of an error on the machine that can interfere with the
safety must be reported to the supervisor.
The skilled technical sta is responsible for lubricating, main-
tenance, repairing and adjusting of the machine. The machine
must be switched o before starting any work on the machine
and should be secured that it can´t be switched on unintentio-
nally.
Exceptions are listed in the regulation EN 50110. The safety
guards must be replaced after finishing the repair and mainte-
nance work.
Operators and technical sta must take attention of the safety
and operating instructions in this manual.