VETRON 5000 Programming Manual page 16

PROGRAMMING MANUAL
12. PROGRAM PARAMETER
-1-10
INFO:
A seam program can be created with the following parameters. When a function is deactivated the according parameter will
not be displayed. To select a progam parameter you have to turn the JOG KEY and push it when the desired parameter appears.
It will now flash. Now you can select the desired parameter setting by turning the JOG KEY. The new setting will be stored by
pushing the JOG KEY again.
NR. PARAMETER
» STITCH LENGHT IN THE SEAM
010 Stitch length 1
011 Stitch length 2
Button
4
018
Stitch length trigger function
NR. PARAMETER
» FOOT STROKE
020 Foot stroke 1
021 Foot stroke 2
16 PROGRAMMING MANUAL VETRON 5000
DESCRIPTION
Main stitch length in mm in the seam. The stitch length can also be entered in the
negative range. The seam will be done in reverse.
Second stitch length which can be selected by pushing button
The stitch length can also be entered in the negative range. The seam will be done
in reverse.
Select function with button
OFF Without function
SWITCH Stitch length will change to 2
When button is release 1
TOGGLE Stitch length will change when button is pressed. When it is
pressed a second time it will change back to 1
DESCRIPTION
Stroke in mm during normal sewing. The value must be set depending on
the thickness and texture of the material to archieve a correct material feed.
2 nd stroke in mm. Can be switched on when you come to thick joints in the seam.
Switching over can be done with key
It can also be done with a knee lever (optional) or with the automatic switch
parameter 027.
1
4
2
3
.
4
stitch length as long as you hold it.
nd
stitch length is back.
st
or the electronic handwheel
3
(parameter 018)
4
stitch length.
st
.
1