VETRON 5000 Programming Manual page 25

» SEWING PARAMETER
100 thread clamp
110 stitch in stitch
120 backtack or condensed
stitches at seam start
121 A stitch count
122 B stitch count
123 A/B repetition
124 A stitch length
125 B stitch length
126 A/B speed
NR. PARAMETER
» THREAD CLAMP
100 Thread clamp (
)
5
NR. PARAMETER
» BACKTACK TYPE
110 Stitch in stitch backtack
010 stitch length 1
020 foot stroke 1
030 thread tension A 1
032 thread tension B 1
041 speed
050 foot pressure
070 foot lift height
135 bobbin thread counter
061 edge value
DESCRIPTION
The following function are available:
OFF = Out of action.
ON = In action.
The function of the thread clamp is equal to a thread wiper function. When the
point of the hook is catching the thread loop the clamp will close. The hook will
pull the beginning of the thread down through the material.
DESCRIPTION
You can choose between:
OFF = Out of action normal backtack.
ON = In action stitch in stitch backtack.
With a normal backtack the direction is changed during the feeding. The penetra-
tion of the needle is not exactly on top of each other. Will be used for not visible
seams. The stitches will be exactly in the same position with the stitch in stitch
backtack. The feeding will be switched when the machine is standing still. It will
be used for visible backtacks with high quality.
PROGRAMMING MANUAL
074 foot position on stop
077 needle position on stop
021 foot stroke 2
027 automatic stroke switch
according to sewing speed
028 automatic stroke switch
speed threshold
029 automatic stroke switch
delay
031 thread tension A 2
033 thread tension B 2
034 thread tension based
on material thickness
038 2 tension level when
nd
switched to 2 nd stroke
054 dynamic foot pressure
PROGRAMMING MANUAL VETRON 5000 25
12. PROGRAM PARAMETER
-10-14
039 release tension on
foot lift
150 thread trimming
140 backtack or condensed
stitches at seam end
141 C stitch count
142 D stitch count
143 C/D repetition
144 C stitch length
145 D stitch length
146 C/D speed