VETRON 5000 Programming Manual page 22

PROGRAMMING MANUAL
12. PROGRAM PARAMETER
-7-14
NR. PARAMETER
» ELECTRONIC RULER FOR EDGE DISTANCE (OPTIONAL)
Edge value
061
NR. PARAMETER
» PRESSER FOOT HEIGHT, PRESSER FOOT POSITION, NEEDLE POSITION
070 Foot lift height
071 Foot lift maximum for operator
074 Foot position on stop
075 Foot position on seam end
077 Needle position on stop
NR. PARAMETER
» TARGET STITCH FUNCTION
078 Target stitch position
22 PROGRAMMING MANUAL VETRON 5000
DESCRIPTION
Following functions are available:
OFF = Edge ruler is deactivated.
0.1–60.0 mm = Edge ruler is activated (Edge distance e.g. 10 mm).
The distance from the needle to the edge can be entered directly in mm. It can´t
be set below the right edge of the presser foot. This setting can only be done by
a service technican.
DESCRIPTION
The setting for the desired hight of presser foot lift is entered here (in mm)
for the program in question.
You can restrict he maximum foot heigth (mm) for the operator here.
Two positions are available (Pedal in 0-position):
UP or DOWN.
Two positions are available (Pedal in 0-position):
UP or DOWN.
Two positions are available (Pedal in 0-position):
POS1 or POS2.
DESCRIPTION
INFO!
Parameter 078 can only be selected when the position of stitch placing is activated
in parameter 085, 086 or 087. The position of the needle point above the material
will be set with this parameter.
1
4
2
3