VETRON 5000 Programming Manual page 31

DISPLAY
» CREATE PROGRAMCHAIN
6
7
8
I S N I D E S E A M
S e a m s i t u a t i o n
9 You can choose between the following type of switch over:
In the seam = Switch will occure before backtack and thread trimming e.g. if you want to join two pieces with a
chain on a program with start and end backtack it will switch to the next sequence before the end
backtack (picture 1). Backtack and thread trimming will be deactivated. The next sequence starts
after the start backtack (picture 2). The start backtack is deactivated.
Picture 1
Seam end = The switch will take place (if part of the program) after the end backtack and thread trimming (picture 3).
The next seam starts with a backtack (picture 4) (if part of the program).
Picture 3
STEP
PEDAL -2
Stitch count
Seam 1
►
Turn the JOG KEY
PROGRAMMING MANUAL
DESCRIPTION
Program Key
Electronic handwheel
Seam 2
to store.
( 10 )
You can enter the postion in the seam
for the switch over here.
Picture 2
Picture 4
13. CREATE PROGRAMCHAIN
1
4
2
3
PROGRAMMING MANUAL VETRON 5000 31
-2-4