VETRON 5000 Programming Manual page 17

» SEWING PARAMETER
100 thread clamp
110 stitch in stitch
120 backtack or condensed
stitches at seam start
121 A stitch count
122 B stitch count
123 A/B repetition
124 A stitch length
125 B stitch length
126 A/B speed
NR. PARAMETER
» FOOT STROKE
027 Automatic stroke switch
Automatic stroke switch
028
speed threshold
Automatic stroke switch
029
delay
Automatic stroke switch
Speed
OFF
010 stitch length 1
020 foot stroke 1
030 thread tension A 1
032 thread tension B 1
041 speed
050 foot pressure
070 foot lift height
135 bobbin thread counter
061 edge value
DESCRIPTION
The machine will switch over to a higher stroke automatically after a certain time
and revolution speed.
INFO!
Automatic stroke switch parameter 027
The stroke on a alternate machine are normally changed by pressing a button or
with a knee lever. The VETRON can do this also automatically with the foot pedal.
By activating parameter 027 it will activate the facility. When the machine is run a
certain time on the 1
stroke. When you sew faster than the 1
lower stroke. The time and revolution is adjustable (parameter 028, 029).
Rotation per minute when switch should take place.
Delay time until stroke switch will occur.
ON OFF
PROGRAMMING MANUAL
074 foot position on stop
077 needle position on stop
021 foot stroke 2
027 automatic stroke switch
according to sewing speed
028 automatic stroke switch
speed threshold
029 automatic stroke switch
delay
031 thread tension A 2
033 thread tension B 2
034 thread tension based
on material thickness
038 2
nd tension level when
switched to 2 nd stroke
054 dynamic foot pressure
step of the foot pedal it will automatically over to a higher
st
step the machine will return back to the
st
Time
STROKE SIGNAL
PROGRAMMING MANUAL VETRON 5000 17
12. PROGRAM PARAMETER
-2-14
039 release tension on
foot lift
150 thread trimming
140 backtack or condensed
stitches at seam end
141 C stitch count
142 D stitch count
143 C/D repetition
144 C stitch length
145 D stitch length
146 C/D speed