General Safety Instructions - VETRON 5000 Instruction Book

INSTRUCTION BOOK
08. GENERAL INFORMATION IMPORTANT FOR SAFETY

General Safety Instructions

This manual and the warning symbols on the machine should
ensure the safe use of the machine, so that no accidents and
injuries may occur. Please read this instruction and also the
safety instructions of the motor manufacturer carefully.
The machine may only be set into operation after this
instruction manual has been read and the operator has
been trained by authorized personal.
The machine may only be used as specified and with the
appropriate safety devices. General safety instructions
must be applied.
Take note of the danger and safety instructions on the
machine.
The machine must be switched o , or plug pulled when
maintenance and other work e.g. changing of needle,
sewing foot, needle plate, feed dog, bobbin or threading
is done, also when leaving the working place.
Daily maintenance work may only be taken out by properly
trained personnel.
Repairs and special maintenance may only be done by
technical personnel or specially trained sta .
Only qualified mechanic may take out work on the electrical
equipment.
Works on live parts are not allowed. Conversions or modifi-
cations to the machine may only be done with the common
safety measures.
Only original VETRON spare parts or parts which are cleared
by VETRON are allowed to use when repairing the machine.
Failure to comply will void the warranty.
The machine can only be used when the whole unit complies
with the EC-Directive.
The connecting cable must be equipped with a country-
specific connecting plug. This must be done by an electrician.
12 INSTRUCTION BOOK VETRON 5000
Notice to the owner
This manual must be at all times be available for the
operator as it is part of the machine. Make sure that the
persons whom are working on the machine read it before
starting the machine for the first time.
The owner must make sure that the machine is in good
working order.
The owner must check that all safety devices are in place
and in working order.
The owner must make sure that only authorize, trained
persons are working on the machine
Operators and Technical Sta
It is the operator´s responsibility to take care of small
adjustments, operating and cleaning of the machine.
The operator has to refrain from any actions that can
interfere with the safety of the machine. There is no
jewelry, changings or rings to be worn while working
on the machine. The clothing should be tight fitting.
Only authorized personnel is allowed on the workplace.
The incidence of an error on the machine that can
interfere with the safety must be reportedto the supervisor.
The skilled technical sta is responsible for lubricating,
maintenance, repairing and adjusting of the machine. The
machine must be switched of before starting any work on
the machine and be secured that it can´t be switched on
by evident.
Exceptions are listed in the regulation EN 50110. The safety
guards must be replaced after finishing the repair and
maintenance work.
Operators and technical sta must take attention of the
safety and operating instructions in this manual.