VETRON 5000 Programming Manual page 19

» SEWING PARAMETER
100 thread clamp
110 stitch in stitch
120 backtack or condensed
stitches at seam start
121 A stitch count
122 B stitch count
123 A/B repetition
124 A stitch length
125 B stitch length
126 A/B speed
Automatic tension adjustment when material thickness changes
Thread tension
in %
70
60
50
40
30
20
10
NR. PARAMETER
» THREAD TENSION
2 tension level when
nd
038
switched to 2 stroke
nd
039 Release tension on foot lift
NR. PARAMETER
» MAXIMUM ROTATION SPEED
040 Speed mode
041 Maximum speed
010 stitch length 1
020 foot stroke 1
030 thread tension A 1
032 thread tension B 1
041 speed
050 foot pressure
070 foot lift height
135 bobbin thread counter
061 edge value
2 mm
DESCRIPTION
Two functions are available.
Function 1 = OFF Thread tension will not change over.
Function 2 = ON
Three functions are available.
Function 1 = OFF
Function 2 = END
Function 3 = ALWAYS (Tension release when foot is lifted)
DESCRIPTION
You can chose between two versions:
Function 1 = PEDAL
Function 2 = CONSTANT Constant sewing speed as selected in parameter 041.
The maximum speed will be entered here.
PROGRAMMING MANUAL
074 foot position on stop
077 needle position on stop
021 foot stroke 2
027 automatic stroke switch
according to sewing speed
028 automatic stroke switch
speed threshold
029 automatic stroke switch
delay
031 thread tension A 2
033 thread tension B 2
034 thread tension based
on material thickness
038 2 tension level when
nd
switched to 2 stroke
nd
054 dynamic foot pressure
Thread tension
rise
4 mm
Material thickness mm
Thread tension will change over.
(No tension release when foot is lifted)
(Tension release when thread is cut)
Sewing speed will be regulated by the posititon of the pedal.
PROGRAMMING MANUAL VETRON 5000 19
12. PROGRAM PARAMETER
-4-14
039 release tension on
foot lift
150 thread trimming
140 backtack or condensed
stitches at seam end
141 C stitch count
142 D stitch count
143 C/D repetition
144 C stitch length
145 D stitch length
146 C/D speed